Hello,
I had a working system and I was able to upload new firmware to our devices (DA14680) using the SUOTA app (from google play store).
However I installed the APP on a new device (old one is no longer available) and now it seams that I can upload but the new firmware does not appears to be flashed correctly.
In the SUOTA APP I can find my device, it connects. after I do "UPDATE DEVICE" and select a image I see the following settings.
SPI selected
MISO GPIO ==> P0_5
MOSI GPIO ==> P0_6
CS GPIO ==> P0_3
SCK GPIO ==> P0_0
Image bank ==> 0
Block size ==> 240
I'm not sure these settings are correct for my device (DA14680), can't find anywhere what they should be.
After "SEND TO DEVICE" I get:
Enable SPOTA_SERV_STATUS notifications
Firmware CRC: 0x82
Upload size: 117493 bytes
Chunk size: 244 bytes
Set SPOTA_MEM_DEV: 0x13000000
Set SPOTA_GPIO_MAP: 0x05060300
Set SPOTA_PATCH_LENGTH: 244
Update procedure started
Set SPOTA_PATCH_LENGTH: 129
send SUOTA END command
Upload completed
Elapsed time: 30.279 seconds
Then a dialog window: Upload completed -> Reboot device? -> OK
The reboot occurs but using the old firmware.
SUOTA APP version 3.190.14
Any suggestions? Thanks.