Hi Dialog,
I want to booting from UART to my DA14585 device. However, i only found doc about DA14580/581/583 Booting from serial interfaces.
Do you have any specific document for DA14585 booting sequence?
Thanks!
Best Regards!
Lionel
Hi,
Hi,
Please advise where to get an example code / application note that describe how to lower CPU clock frequancy to 100K, 1M
*Note: BLE RF is not required in this mode --> disabled
Regards,
Roie
Hi,
Please advise how to maintain low power consumption while sampling every 1ms ADC
(an example code / Application note would be great)
Regards,
Roie
Hello Dialog,
Our block diagram is consist of two sensors, one external microcontroller, and one DA14585 BLE.
Our main goal is to reduce power consumption, for that, we thought two types of case
Case i: By Keeping DA14585 BLE in sleep mode(Deep Sleep or Extended Sleep). When an external microcontroller sends an interrupt to DA14585 BLE it wakes up and starts advertising.
Case ii. Power off DA14585 BLE completely, When an external microcontroller sends an interrupt DA14585 BLE has to be powered on first and starts advertising.
Hi,
Please advise where to download example code that uses FreeRTOS with Keil environment
Regards,
Roie
Hi,
I'm tring to use the wrbl example code using SmartSnippets 2.0.8.1382
The wrbl.elf file is build okay, but the debug configuration is missing
Please advise how to configure the debugger
Regards,
Roie
Dear support,
Hello Support,
Can the DA14585 interrupt output its own RF output status using the DA14585 GPIO-pin?
For example,
I would like to output the status of each output on / off from GPIO-pin,
when the DA14585 turns ON the RF output or turns OFF the RF output.
Can I use BLE_RF_DIAG_IRQ?
i want to print floating point number in uart ,is it possible?then how?
