Hello MT_Dialog,
We are investigating the Beacon technology in order to invest in it.
I have downloaded the project fh_project_dialog_beacon (DA14580_DialogBeacon_3.40.6_0) and I use for the tests the DA14580 Development kit (Basic version).
I would be grateful if you answer the following:

1. Dialog Semi(DS) has also licensed the DA14583 chip, which is similar to DA14580 plus an 1Mbit SPI Flash. Can also the project fh_project_dialog_beacon support the DA14583 chip?
2. The project fh_project_dialog_beacon can also be configured (CFG_HW_CONFIG) in order to support the DA14580 SmartTag proximity rev2 reference design. DS has also licensed a new project for smart tags the DA1458x_SMARTTAG_5.20.2. What's the main differences between the 2 projects?
3. Your site refers to Beacon programmable UUID, Major, Minor values and advertising frequency. How is this accomplished? Could you point out the source code lines in the above mentioned project where this task is implemented? Does DS provide an application which supports this capability?
4. I made some tests (in HW_CONFIG_BEACON_REF mode) by defining or not the CFG_CONNECTABLE_ADV_MODE. I confirmed that in the non-connectable mode I only could see the Beacon data and in the connectable mode I additionally could connect and reading the characteristics. But I didn't see any difference in the power consumption for these 2 modes. How is this explained?
5. In the same mode I defined the CFG_PRF_SPOTAR, but when I tried to run SUOTA application on my mobile, the app could not see the Beacon. Please notice that I made the same test with prox_reporter application and followed the steps in AN-B-10 and the FW update was successful.

Thank you in advance,