Hello,
I try to make an application based on SmartTag example. I try to make it work on the DA14580 Basic Kit, but when I launch the debug, the application stay in loop or after a few seconds I can see the Bluetooth access point (and the LED stay green) but I can't connect to it with my smartphone application.
I verify with the ref designs, it will work with the Basic Kit, I just change the LED and BUTTON PIN.
Have you any idea about how i can fix it ?
BR,
Hi sbourahla,
So when the debugger is not running you can connect? Did you check if the smarttag example has the sleep modes disabled when you use the debugger?
Best regards,
RvA
Hi RvA,
I disabled the CFG_EXT_SLEEP define in the da14580_config.h file but I have the same problem when I launch the debugger, i can't see the LED blinking for advertising and I am not able to connect over Bluetooth.
BR,
sbourahla
Hi sbourahla,
In the file da14580_config.h you should undefine both extended and deep sleep:
Best regards, RvA
Hi RvA,
Thank you for your help, I try this but it doesn't work. I see a flag "DEVELOPMENT_DEBUG ", do you think it's will be help ?
Best Regards,
sbourahla
Hisbourahla,
I just did a test with the Basic evaluation kit and the proximity project under SDK 3.0.8.0. making the #undef statements worked with that configuration. Can you give more details on your exact configuration?
Best regards, RvA
Hi RvA,
Yes the example on the SDK work great in debug mode. But Only with the SmartTag Ref Design example I can't debug the application, I don't understand how to fix this issue. May be the SmartTag application use the SPI Memory for some reasons but in debug mode (UART mode jumper for this) it can't access to it due to the configuration ...
Best Regards,