Hi,
I have recently started to work with the DA14531 Kit-USB.
After reception of the board I have tested the Demo. Everything was fine: led was blinking and the BD address was received by my computer terminal via UART.
Hi Dialog,
Problem Statement
- Register a GPIO interrupt/ISR using GPIO_RegisterCallback( ) and detect if the short press and long press on the button when the system is up and running.
What I tried
Hi,
I tried to download the blinky sample application to my brand-new development kit.
Following all steps described in "UM-B-049 Getting started with the DA1458x Development Kit–Pro", I come to the step 17 of section "4.1
Run an example on the DA14580/581/583", and got this error:
Include "C:\\Users\\hp\\Downloads\\GreenVirtue\\Dialog\\SDK 5.0.4\\SDK 5.0.4\\DA1458x_SDK_5.0.4\\DA1458x_SDK\\5.0.4\\projects\\target_apps\\peripheral_examples\\blinky\\Keil_5\\..\\..\\shared\\sysram.ini"
________^
*** error 56: cannot open file
我试图运行俄式薄煎饼ky Example as shown in the 'Getting started with the DA1458x Development Kit – Pro' guide. I get to step seven, the step where you check that the SW device has been detected correctly. However when I try to do this, no device is recognized. When I try to run the debugger after this it leads to the error: "No Cortex-M SW Device Found".
How can I make the debugger recognize my board? What could I have done improperly along the way that would lead to this problem?
Thanks
I am using the Basic DA14580 development board, following instructions in UM_B_025 DA14580_581_Bluetooth_Smart_developement_kit-Basic V2.2, using Keil 5.15. The Blinky example runs on the board fine, i.e. LED blinks. However, the Tera Term is not showing any output. I am connected through COM9, Jlink CDC UART port in the drop down. The appearance of that in the dropdown should indicate it's detecting the device correctly, but yet no output in the terminal.
任何建议吗?谢谢你！
