After messing with the register settings quite a bit i cant seem to figure out why I'm unable to get audio in both line mic1 and line mic2. I've been using USB PB REC as a starting point. All of the input settings seem to indicate that both channels are enabled\.
Device:
Hello,
I have attached a script for reference for USB Record.
Are you sure it is the input side is the issue ? is the data changing on the I2S Dout Pin when signals are applied to the MIC's ?
Normally it is the setup of the PC that causes issues in the USB Record path ?
Does your message imply you are able to one mic working ?
Yes, we only see audio through one mic.
I would try using the script attached, just tried this in the lab and worked fine with two mics.
Tried the attached code with the same result. See attached outputs.
Are you taking this out on the headphone path to get your capture on the Oscilloscope ?
Is the path you want Mic to Hp ?
Attached a MIC to HP path, which two Mic's out to the HP.
No change, I am using the line mic1 and line mic2 (jacks J16 and J18). With J16 I seen no audio out of the Headphone L or R.
尝试连接脚本,它使用均ntial Inputs and Output is also Differential.
Is it always one specfic Mic Channel you are not seeing.
Registers 0x6C and 0x74 are the mixers that select where the signal is being brought from.
No change. Do these scripts utilize the sidetone or are both mic one and two routed back to the headphones in software / through the microcontroller? I know the sidetone is only one channel. The connector I'm unable to get up is J16.