DA7218 ALC erratic behavior

⚠️
Hi there.. thanks for coming to the forums. Exciting news! we’re now in the process of moving to our new forum platform that will offer better functionality and is contained within the main Dialog website. All posts and accounts have been migrated. We’re now accepting traffic on the new forum only - please POST any new threads at//www.xmece.com/support. We’ll be fixing bugs / optimising the searching and tagging over the coming days.
5 posts / 0 new
Last post
cpeng03d
Offline
Last seen:9 months 5 days ago
Joined:2020-03-02 21:14
DA7218 ALC erratic behavior

Hi dialog:

I have been experimenting DA7218 ALC features on the eval board with Canvas. So far there are some erratic behaviors I could not reason with.

I used a tone generator as a source.

If the input to eval board is audio jacks, ALC behaves fine.

If the input to eval board is real sound from a speaker captured through the LP mic, ALC has a weird behavior describes as follows:

最小设置为-15 dbfs,最大5 dbfs,使用hybrid mode.

when noise level is set below -67dBfs, ALC behaves fine

when nose level is set > around 60dBfs, ALC fails to function! I turned up and down the volumn, no auto adjustment on the level as observed previously.

What's going on? Why a slightly higher noise level cripples ALC?

Device:
ED_Dialog
Offline
Last seen:3 weeks 3 days ago
Staff
Joined:2017-09-18 11:54
Hi,

Hi,

Let me look into this and get back to you.

Kind regards,

ED

ED_Dialog
Offline
Last seen:3 weeks 3 days ago
Staff
Joined:2017-09-18 11:54
Hello,

Hello,

Do you have anti clip enabled?

Could you share you set-up script?

Kind regards,
ED

cpeng03d
Offline
Last seen:9 months 5 days ago
Joined:2020-03-02 21:14
No the anti-clip ctrl is not

No the anti-clip ctrl is not enabled.

Here are my set-up script:

ALC noise set to -42 dBfs, ALC stopes working below the min threshold.

If you have it set to -67dBfs and lower, it will work.

Please take a look. Thanks.

ED_Dialog
Offline
Last seen:3 weeks 3 days ago
Staff
Joined:2017-09-18 11:54
Thanks!

Thanks!

We would recomend enabling Anti-Clip. Do you calibrate the ALC?