Hello dialog:
I use the jlink to use command line mode to write OTP burning, can't burn write success, I have answered. 6.8 V.
My order is: SmartSnippets. Exe -type otp - chip DA14580-123456-01 - the jtag CMD write_custom_code - the file "C: \ 5920 _0300. Hex" - offset 0 x0000 - y
But burning the last hint otp memory'm failed.
Where is this problem will be in the, is my command is wrong, or need to burn what steps?
Device:
I just tried to use first SmartSnippets software click connect, then write in the command line to burn.But couldn't find any SmartSnippets software that connect with the command line.Could you tell me how to go to the connect to send the command line to achieve?
Burning OTP need to download on board beforehand a programmer used to configure and implement burning the firmware, this in the UI interface is implemented by the connect button, when you click on the connect will see in the Log under relevant information.
You can refer to the command line
SmartSnippets. Exe -type booter - chip chip_version [- the jtag jtag_serialNumber | - com_port portNumber]
[- sys_ctrl_reg b1] [- gp_ctrl_reg b2] [close] - [- gpio pinId] [- uart TxId] - the file filename [-] y [- nomessages messageFilter]
Downloads the file to DA14580 using UART Booter tool. If a "CRC does not match" shows up, both please
Run the command again and then press the hardware reset button on the board to restart the download process.
Download this command is used to specify the firmware to the board of RAM, need more information is also available in Smartsnippets documentation at the end part of the view that this is the second.
You need to select a suitable firmware to perform the subsequent record, for example, if you intend to use JTAG burning should download jtag_programmer. Bin
The firmware are stored in C: / Users/YourUserName/SmartSnippets/resources directory, the SDK Utilities directory below should have