Hello Dialog,
I'm using a DA14531-00FXDEVKT-1 to connect the PC terminal to SmartConsole Android App. Firmware on the dev board is Codeless Standalone Set-One.
I can send a string from the PC terminal to SmartConsole using pipe char. But can't send AT commands to control the module.
From the SmartConsole, using "AT+PRINT=sometext" I get response "OK" but nothing reaches the PC terminal.
Best regards
Filipe
Device:
Hi filipesousa,
Could you please double check if you have the proper Hardware and Software setup?
http://lpccs-docs.dialog-semiconductor.com/UM-140-DA145x-CodeLess/howToUse.html#hardware-setup
http://lpccs-docs.dialog-semiconductor.com/UM-140-DA145x-CodeLess/howToUse.html#software-setup
Thanks, PM_Dialog
The board I have is the small USB dongle,DA14531-00FXDEVKT-U.
The hardware is not the same as the pictures. What is the correct configuration for the DIP switch? Currently I am using the factory standard.
Is a transparent serial channel even possible with this board?
Hi filipesousa,
Please read section2.2. Hardware Setupfrom theUM-B-140: DA14531-DA14585 CodeLess.
According to the user guide:
"The DA14531 USB kit cannot be configured to boot from SPI flash and also operate a 2/4 wire UART - for this reason it is not well suited to being used as a platform for CodeLess."
http://lpccs-docs.dialog-semiconductor.com/UM-140-DA145x-CodeLess/howToUse.html
The supported boards:
- DA1458x Pro Motherboard with DA14585 daughterboard
- DA1458x Pro Motherboard with DA14531/DA14531 Module daughterboard
- DA14585 Basic board
——其他铜stom board using DA14531/DA14585 with a 2 wire UART will also work
Supported modules
- BLE5.0: DA14531 Smartbond TINY™ Module
Do you have any other DA14531 DK to test it?
Please a previous forum ticket:
https://support.dialog-semiconductor.com/forums/post/dialog-smartbond-bluetooth-low-energy-%E2%80%93-hardware-device-reference-designs/codeless-code
Are you booting from SPI Flash?
Thanks, PM_Dialog