rwble ASSERT_WARNING issue

Hi DialogSupport,

I am working on project where i am working on I2C base touch sensor. I have designed the custom board using DA14583 MCU and IQS333 touch sensor MCU.

I have written the firmware and now i am working on sleep mode configuration. first i have followed is by defining/Enabling the ARCH_EXT_SLEEP_ON.
const static sleep_state_t app_default_sleep_mode = ARCH_EXT_SLEEP_ON;

if i run the code, it immediately enters into attached sinppet and
hold into ASSERT_WARNING(0); line and not written any wake up API function yet.

void lld_sleep_compensate_func_patched(void)
{
uint32_t dur_us;
uint32_t slot_corr;
uint32_t fine_corr;

// Get the number of low power sleep period
uint32_t slp_period = ble_deepslstat_get();

// Sanity check: The duration of a sleep is limited
ASSERT_ERR(slp_period < LLD_EVT_MAX_SLEEP_DURATION);

// Convert sleep duration into us
dur_us = lld_sleep_lpcycles_2_us_sel_func (slp_period);
slot_corr = dur_us / 625;
fine_corr = 624 - (dur_us % 625);
if (fine_corr == 0)
fine_corr = 1;

// The correction values are then deduced from the sleep duration in us
ble_basetimecntcorr_set(slot_corr);
ble_finecntcorr_set(fine_corr);

// Start the correction
ble_deep_sleep_corr_en_setf(1);

if ((DEVELOPMENT_DEBUG) && (USE_POWER_OPTIMIZATIONS))
{
slp_period_retained = slp_period;
// if this Assertion hits then the LP ISR lasts longer than the time
// that has been reserved via LP_ISR_TIME_XTAL32_CYCLES and LP_ISR_TIME_USEC.
if (sleep_lp_cycles && (sleep_lp_cycles < slp_period))
ASSERT_WARNING(0);
}

}

Please note that i have a RDY_PIN interrupt coming from sensor, which interrupt my MCU whenever there is low pulse(this pulse interrupts MCU every 10ms ) and enter into interrupt handler function to read data from sensor.

while debugging i encountered an behavior of the device that is, whenever i get I2C_RDY pin interrupt of sensor at that time the device goes to ASSERT_WARNING (0);
However, if i remove RDY_PIN interrupt the code does not enter into ASSERT_WARNING(0);

Can any one help me to resolve issue. how i can debug this and work as required. It's urgent for me to debug.

Thanks and Regards
Rohit