⚠️
Hi there.. thanks for coming to the forums. Exciting news! we’re now in the process of moving to our new forum platform that will offer better functionality and is contained within the main Dialog website. All posts and accounts have been migrated. We’re now accepting traffic on the new forum only - please POST any new threads at//www.xmece.com/support. We’ll be fixing bugs / optimising the searching and tagging over the coming days.
2 posts / 0 new
Last post
Thu, 2017-08-10 06:38
#1
shmaglit
Offline
Last seen:2 years 5 months ago
加入:2017-08-04 08:45
ZOR Antenna Surface Finish

Hi,

AN-B-027 application note presents antenna designs and matching component values for each antenna.
It says that these values are PCB thickness and enclousure material dependent. But it says nothing about PCB surface finish.

I've found in this forum and in RefDes documentation that the proposed surface finish for IFA antennas is solder mask over bare copper.
But I am confused about surface finish for ZOR antenna. On the photos in AN-B-027 all antenna area looks solder mask free with ENIG finish.

你能,请澄清什么PCB surface finish is recommended for ZOR antenna design?

BR,
Lev

Keywords:
ZOR Antenna Surface Finish
Device:
DA14580
Fri, 2017-08-11 16:31
MT_dialog
Offline
Last seen:2 months 2 weeks ago
Staff
加入:2015-06-08 11:34
嗨shmaglit,

嗨shmaglit,

The antenna itself can be copper ir gold plated, but it should be covered with a solder mask.

Thanks MT_dialog