UM-B-064 conflict between Figure5/schematic and Table4

⚠️
Hi there.. thanks for coming to the forums. Exciting news! we’re now in the process of moving to our new forum platform that will offer better functionality and is contained within the main Dialog website. All posts and accounts have been migrated. We’re now accepting traffic on the new forum only - please POST any new threads at//www.xmece.com/support. We’ll be fixing bugs / optimising the searching and tagging over the coming days.

3 posts / 0 new

Last post

Wed, 2017-07-26 07:03

Kazuki Yamamoto

Offline

Last seen:4 months 3 days ago

加入:2014-02-14 04:32

UM-B-064 conflict between Figure5/schematic and Table4

Hello,

I am designing sensor board using data in UM-B-064 user manual.(dated 10-Mar-2016 )
When looking at Table 4, it says connections to BMM150/CSB3 is P1_0 used, while Figure5 shows P2_9 is used.

Which is correct connection? I am using Murata module which is DA14580, WLCSP version used inside.

Thanks && Regards,
Kazuki

Keywords:

UM-B-064

Device:

DA14580

Wed, 2017-07-26 16:21

MT_dialog

Offline

Last seen:2 months 1 week ago

加入:2015-06-08 11:34

Hi Kazuki Yamamoto,

Apparently its a mistake on the document, from the source code the pin assigned for the chip select of the BMM150 is the pin P2_9, you can check that in the user_platform.h file of the IoT reference design code.

Thanks MT_dialog

Thu, 2017-07-27 07:07

(Reply to #2) #3

Kazuki Yamamoto

Offline

Last seen:4 months 3 days ago

加入:2014-02-14 04:32

Hello MT_dialog,

谢谢你的确认。我希望the document updated immediately

Thread is closed.

Kazuki