⚠️
Hi there.. thanks for coming to the forums. Exciting news! we’re now in the process of moving to our new forum platform that will offer better functionality and is contained within the main Dialog website. All posts and accounts have been migrated. We’re now accepting traffic on the new forum only - please POST any new threads at//www.xmece.com/support. We’ll be fixing bugs / optimising the searching and tagging over the coming days.
2 posts / 0 new
Last post
Tue, 2018-08-28 06:47
#1
imaizumi.k
Offline
Last seen:3 weeks 2 days ago
加入:2018-06-22 01:18
Power on reset and Undervoltage detection

Dear Dialog support team,

I want to know the detail information about reset specification.
Could you tell me below questions ?
1. Power on reset rising threshold voltage
2. Under voltage detection threshold
3. POR detect to RST deassertion delay
4.我可以改变“欠压检测threshold" and "POR detect to Reset deassertion delay" ?

Best Regards,
Katsutoshi

Keywords:
Reset
Device:
DA14580
Tue, 2018-08-28 16:38
PM_Dialog
Offline
Last seen:8 hours 29 min ago
Staff
加入:2018-02-08 11:03
Hi imaizumi.k,

Hi imaizumi.k,

  1. The Power-On-Reset (POR) is not synchronized to any clock, but it is related to VDD. If the VDD reaches 600mV it takes about 2us to release POR. This means that, if the VDD stays under 600mV, then the POR will not be released.
  2. There is not any under voltage detection threshold in DA14580. Be aware that BOD functionality is not supported in DA14580.
  3. The POR and RST are completely independent blocks, so there is not any de-assertion delay to detect the reset signal. The RST is only an input to generate a reset and the POR is an internal block checking the VDD.
  4. Given the answers #2 and #3, you should not "Under voltage detection threshold" and "POR detect to Reset de-assertion delay"

Thanks, PM_Dialog

Accepted answer