Hi there
Can I check if DA14531 supports Enhanced GATT? If so, how?
Also, how does the device support 3 concurrent BLE connections?
Thank you.
Warmest Regards
Richard
Device:
⚠️
Hi there.. thanks for coming to the forums. Exciting news! we’re now in the process of moving to our new forum platform that will offer better functionality and is contained within the main Dialog website. All posts and accounts have been migrated. We’re now accepting traffic on the new forum only - please POST any new threads at//www.xmece.com/support. We’ll be fixing bugs / optimising the searching and tagging over the coming days.
Hi there.. thanks for coming to the forums. Exciting news! we’re now in the process of moving to our new forum platform that will offer better functionality and is contained within the main Dialog website. All posts and accounts have been migrated. We’re now accepting traffic on the new forum only - please POST any new threads at//www.xmece.com/support. We’ll be fixing bugs / optimising the searching and tagging over the coming days.
Hi There,
谢谢for your question online and for your interest in our BLE solutions. I would recommend first checking theUM-B-119: DA14585-DA14531 SW Platform Referenceand section 1 and .2.4. Bluetooth Low Energy Software. Please see Figure 2 BLE Protocol Stack Layers and table Table 3 da1458x_config_basic.h configuration flags.
CFG_MAX_CONNECTIONS :
Determines the maximum concurrent connections supported by the application. It configures the heap memory allocated to service multiple connections. It is used for GAP central role applications. For GAP peripheral role it should be set to 1 for optimizing memory utilization.
The MAX value for DA14585/586 is 8.
The MAX value for DA14531 is 3.
You can also check theDA14585/DA14586 - DA14531 Multiperipheral Example. This example example demonstrates how a single peripheral can be connected to more than one centrals ( in case of DA14531 ) .
谢谢, PM_Dialog
谢谢PM_Dialog!