Hi teams,
I am trying to start my wearable device development with DA1469x.
Have noticed that there are generic DA1469x SDK, and another special purpose SDK for DA1468x for wearable.
What is the best practice if I develope wearable device based on DA1469x chip?
Should I analyse the structure of wearable SDK and migrate the required components to generic one, or another way existing?
How can I verify that my system is entering sleep mode? Are there specific callbacks that get called when going to sleep/waking up?
My code is currently calling the following functions:
Please provide information about the production line tool for the DA1469x chip set.
There is some desire for our system to have a single Periphreal Aggregator that has several Central nodes acting as sensor data. \
Can the Periphreal recieve data communication from a multitude of Centrals?
Can it connect to multiple centrals?
If it connects to a single central will it continue to recieve data from the from the other centrals?
--------------- (On a different topic) ------------------
Can a periphreal send data to a central without being told to send data?
Hi guys,
We are considering setting our sensors into central role, and only connecting to our system when certain conditions are set. Once connected we are considering the possibility of switching modes so the "master" can get the data off our sensor, and perhaphs configure settings for the next round of sensor data.
We are partially considering this as a way to save power.
Does Dialog allow the device to switch from Periphreal to Central and back again? Can a dialog chip be set to be both Central and Perhiphreal for different sensors in a network?
Hi, Dialog teams.
I am planning to develop several beacon & tracker devices based on DA1469x.
Because these devices will partially use BLE Mesh functions, I need both generic SDK & Mesh SDK.
Currently, Mesh SDK seems to be only supporting DA1468x chips.
The following is my questions:
1. When Mesh SDK will also support DA1469x chips?
2. Any plan to merge default SDK & Mesh SDK? Or how can I use Mesh functions in generic SDK?
Does the dialog system have a way to turn on the Constant Tone Extension (CTE) that is specified in BLE 5.1.
We are attempting to calculate the Angle of arrival using CTE on all our packets. But we were not certain if Dialog devices handle this yet?
Thanks you,
John
Hi PM_Dialog,
I recently have some diffculties during developing the program on the proDK.
In my program, I use theP0_14andP0_15as I2C or GPIO function instead of USB function. But the pins can't generate any signal and even can't read/set the pins to high/low correctly. Even though, I checked and modified the USBPAD_REG[USBPAD_EN] bit, the problem is still exist.
Is there a way to provide external interrupts to the DA1469x SoCs? The GPIOs do not have trigger interrupt functionality, so what perpheral can be used to detect rising/falling edges and issue interrupts to the M33?
Is there a delay() function in SDK10 that is equivalent to the sdk/peripherals/hw_cpm_delay_usec() function from SDK1?
