我在测试peripherals_demo，发现在html文档中
| | TX(P4_1)|---------->|RX FT232 USB|<---------->|USB |
| | RX(P4_2)|<----------|TX GND|
但是在代码中
# define CFG_GPIO_UART2_TX_PORT (HW_GPIO_PORT_4)
# define CFG_GPIO_UART2_TX_PIN (HW_GPIO_PIN_2)
# define CFG_GPIO_UART2_RX_PORT (HW_GPIO_PORT_4)
# define CFG_GPIO_UART2_RX_PIN (HW_GPIO_PIN_1)
发现是冲突的
我两种方式都实验了，但是UART2上面还是没有数据输出，求助。
BR
Hi Dialog,
I'm using a pro DEV kit for 14681-01. I'm running ble_adv demo code with advertise interval modified to 1000ms (confirmed using nrF connect app).
I'm using the smarsnippets Toolbox V4.4.3.142.
Im getting a average current of about 130uA after letting it settle. If i change the advertising interval to 5000ms i get around 110uA.
My question what current is the power-profiler measuring is it the current for the whole board or just the chip?
Is there any setting I need to do for power-profiler?
Are these current readings normal?
Hello!
I have a question concerning using the DA14681 and 14583 dongles to test the capturing of RSSI values. When, I open the putty program to begin logging RSSI values under the ble_central_task program, the values seem to sometimes fluctuate around -120 and stay there in that state.. While in that -120 state, any signal interference (covering the dongle) will not affect the change in RSSI as it continues to fluctuate around -120. Other times, the values are accurate and around the appropriate RSSI value corresponding a certain distance.
Hello,
I am trying to flash my DA1468x Development Kit Basic with SmartSnippets Studio (v1.2.3.588) but it doesn"t work.
I select my project, then I click on "program_qspi_jtag_win" and I get this message :
.......................................................................................................................
..
.. QSPI PROGRAMMING
..
.......................................................................................................................
请问一下：
我想利用DA14681 Development Kit - Basic软件sdk是v1.0.8.1050，
作为主机扫描其他蓝牙从机(比如580的beacon)，然后通过串口打印从机的相关信息(SSID,MAC,ADV DATA等)应该使用哪个程序修改，如何修改。
或者是否有相关文档说明？
非常感谢！
Hi Dialog,
Dose each DA1468x contains a unique 48-bit IEEE address (BLE MAC)?
Thanks
useage of void sps_tx_data(ble_service_t *svc, uint16_t conn_idx, uint8_t *data, uint16_t length)
hi support：
请问14681有无操作系统的裸机程序吗？我想开发bootloader。
或者有bootloader的demo吗？
Hi Dialog,
We have a requirement of setting peripheral to standby mode before entering sleep, and when wake up, read from I2C peripheral.
Where should I place application codes for these purpose? Is there any sample code for wakeup and sleep event handler?
您好，请问下，DA14681是否有硬件MAC地址，每个设备都不同？
