Hi,
我們依據 DA14683 development kit Pro電路重新設計 DA14683 電路板，在更新 firmware遇到問題.
我們使用 DA14683 development kit Pro 作為 JTAG工具，並對以下接點連線
DA14683 development kit Pro --> 我們的DA14683 電路板
JTAG interface
J3-SWCLK/ADC7/P2_4 - > SW_CLK pin of custom board.
J3-SWDIO/ADC4/P0_6 - > SWDIO pin of custom board.
UART interface
J4-ADC0/P1_2 - > UART_TX of custom board.
J3-P2_3 - > UART_RX of custom board.
Power in
Hello!
我使用自定义board on chip DA14682. My board use USB only for charge lion battery, USB line D+ and D- not used.
Charging via 5v adapter. In this case, the charging current is not more than 90 mA. Is it possible to increase the charge current in this case?
BestRegards.
Denis.
Hi Dialog teams,
3V is the cut-off voltage of the battery(15mAH), but the battery voltage is discharged to 1.8V. Why？
The following is param.
Hi,
I have custom DA14683 boards and got problem to loading firmware.
I program my custom board by using DA14683 development kit Pro
JTAG interface
J3-SWCLK/ADC7/P2_4 - > SW_CLK pin of custom board.
J3-SWDIO/ADC4/P0_6 - > SWDIO pin of custom board.
UART interface
J4-ADC0/P1_2 - > UART_TX of custom board.
J3-P2_3 - > UART_RX of custom board.
Power in
J4 - VBAT+ - > VBAT of the custom board.
Hi Diaglog teams,
I can find cursor(mouse) example in SDK, do you have cursor algorithm running on DA14683?
Can the performance of DA14683 meet the requirement of cursor(mouse) algorithm?
Thanks.
Hi Diaglog teams,
Can you give me to example of i2c interrupt in DA1468x?
The following example can't use i2c interrupt.
Thanks.
Hi Dialog teams,
have Dialog recently published an example that shows how to i2c interface with 6 axis IMU in DA1468X?
This example of i2c EEPROM is not suitable for us .
Thanks.
Hi Dialog teams，
Where to download the battery profiler tool？
6 Battery Profiler Too of um-b-075_da1468x_state_of_charge_functionality_v1.2_0.pdf mentioned the tool.
Thanks.
Hi Diaglog teams,
How to use this tool:Power Profiler, refer to the attached pdf, it has not shown the signal all the time.
HW:DA1468x/DA1510x PRO
USB2 of DA1468x/DA1510x PRO connect to Host.
Thanks.
Hi Diaglog teams,
Please help me to check how modify the following parameter when useing new battery.
static const int16_t vol_dis_low_0[VOL2SOC_LUT_SIZE] = {
3391, 3430, 3481, 3528, 3564, 3595, 3639, 3689, 3740, 3797, 3883
};
static const int16_t vol_dis_high_0[VOL2SOC_LUT_SIZE] = {
3633, 3676, 3730, 3779, 3818, 3850, 3891, 3939, 3988, 4042, 4123
};
Thanks.
