Dear
I am using the SLG46620 device and the CNT components as counters, I would like to know if the width of the geerated set can be changed or is it by default.
Attached image.
Another question regarding this would be if it is possible to generate a pulse half the width of the one provided as an attachment in image 2.
Thank you
Regards
Hello,
We're developing a product that is using the DA9061 PMIC and have been using the motherboard dev kit to test it. Recently it stopped working as I can no longer connect to blank chips using the DA9061 GUI software.
If I place a blank chip in the socket I immediately start getting I2C errors and i can never get past them. If i place a programmed chip in the socket, the software seems able to connect normally.
Thanks,
Daylan O
你好：现在我的蓝牙设备需要绑定，但不需要配对码，使用下面配置：
Dear Sir,
Would appreciate if you could be provide me a copy of SLG59M1557V RoHS certificate.
Thanks.
Regards,
lisa
Hi there,
I working a project base on DSPS project of 14580, and I modify the following changes for the default DSPS project:
1. #undef CFG_MEM_MAP_EXT_SLEEP
2. change app_default_sleep_mode value to ARCH_SLEEP_OFF
3. change GPIO_UART1_RX_PIN to GPIO_PIN_2
4. use CFG_UART_SW_FLOW_CTRL instead of CFG_UART_HW_FLOW_CTRL
Hello,
I wish to use my 14580 development kit to burn OTP into my custom board using JTag. On the custom board side, I wish to implement aTC2030-NL-FPfootprint to connect to the 14580 development kit via JTag.
I am looking to implement a frequency range detection function like what is shown in the link below. The cookbook states that it can be done on any GreenPAK. However, the SLG46620V does not have the frequency detect mode on its Counter/Delay generators. Is there a way to implement this function on the SLG46620V?
//www.xmece.com/greenpak-cookbook/frequency-range-detector
Thanks
On Sheet 11 Table 2 of the SLG46170 Data Sheet it references typical delays, the first row references a tpd forDigital input to PP 1X. How is this defined ? Is this input (pad) to single output (Push-Pull) pad ?
Also, what's the difference between "Digital input" and "Low Voltage Digital input"? Both are referenced in Table 2.
Device Number:
SLG46170
Hello,
I was wondering if the DA9063 LDOs can load share at common voltages. Particularily LDO1 and LDO 2.
Best - JT20
