We are trying to run SmartSnippets command line.
When we run versions from 3.4 and above (from GUI) we get blue-screens on our Windows 10.
只有version 3.0 works from GUI, but we cannot run it from command line ("no FTDI...").
If you have any idea about a version change that could cause blue screen, please let me know.
I want to try version 3.2 to see if it works both from GUI and from command line.
We recently ordered some SLG46721 chips programmed. Previous orders of these chips were marked in accordance with the datasheet 46721. The latest delivery we receive was stopped at our incoming inspection because the chips are marked 44340. Can you please help me understand this discrepancy. I can’t find any information on a part with this 44340 marking.
We are investigating the use of a GreenPak device for a low power application and want to estimate the current usage. The application will use digital only macrocells.
Does the ''Chip Quiescent" current in the 'Typical Current Estimated for Each Macrocell' tables cover the use of multiple digital macrocells (eg. DFFs, LUTs, Counters and I2C), regardless of how many are used? Or is that an average that we should multiply by the number of those digital macrocells we expect to use?
Thanks
Check out the app note below that describes how to create an SPI digital ISDN telephone handset using two Dialog GreenPAK ICs:
Check out the app note below that presents several examples on how to use the GPIOs in SLG51000 for various applications:
Hi,
I want to get value about GAP Service and Hid Service.
For example, property, Hid Report Value and Report Reference.
I tried to get the value using LightBlue and nRF Connect, but the data was not visible on both applications.
Does dialog have a tool like LightBlue?
Dear Sir/Madam
We are looking to implement an adjustable threshold/hysteresis analogue non inverting Schmitt trigger
At present we have an implementation of this using discrete components (op-amp based...see attached image) and we were wondering if it is possible to implement this in one of the GreenPAK devices.
If this is possible, could you please recommend a development board and a suitable configurable GreenPAK device for implementing the above
Thanks
Kindest regards
Hi,
I have found this topic:https://support.dialog-semiconductor.com/forums/post/pmic-audio-and-hapt...
They use the Zynq Version of the Chip for their Artix FPGA.
They did mount the inductors for the rails which they didn't use. So what happens to the chip, if they wouldn't mount the inductors? Will the chip start or not? If the rails are enabled, is it ok to let them float and don't mount the inductors?
Hi,
what is the order number for ther DA9062 if we want to use the Artix-7 XC7A15T?
Does Dialog Semi have an ordering number here or do we need to order the blank one DA9062-00 and programm it?
Thanks
Kind regrads.
Hi,
when I want to order an unprogrammed DA9061, what must be the xx stand for?
Kind Regards.
