Hi ,
1)We designed a custom board usingDA14531MOD-00F1DB-PBLE Module .
2)The issue is while trying to connect BLE Module (in custom Board) using "Smart snippet" software but it's keep loading and board didn't detected. (J link plus segger and SWD Interface used)
a)In our custom design "Reset" is pulled High using pull up resistor (Smart snippet software but it's keep loading and board didn't detected & in J link plus Green LED glowed).
Hi Dialog team,
I want to reduce the Tx power level (output power) of my DA14531_TINY_Module. I have already seen your 4.7 DA14531_FAQs/RF_Radio.
Is there any other possibility to change the Tx power level in my application code itself? So that I can enable that Tx power range while I am flashing my program into DA14531_TINY_Module.
I really need an answer to this.
Thank You in advance.
D.RAVIKIRAN
我一直试图让SUOTA tutorial for the DA14531 to work on a Pro Dev Kit with DA14531MOD daughter board, but I keep getting the error "Same Image Error" when trying to do an update from an android phone with the Dialog SUOTA app.
http://lpccs-docs.dialog-semiconductor.com/Tutorial-BLE-SUOTA-DA145x/bui...
Hi
Could you tell me the average of power consumption in different power modes?
Thanks
I foundthis pagefrom DigiKey which says the following about "Just Works" bonding on Bluetooth 4.2+ devices:
Hi Dialog,
Based on my application, I need to create multiple threads ,to run each thread independently. For example I have two task
1. LED has to blink for every 500 ms
2. Get one Pin Status whether its high or Low
I have used app_easy_timer() from ble but it needs BLE to be active.
How do i initialise a task , can you post a simple led blinking task.
Ragards,
BALAJI
How can I add a new service or characteristics to my bluetooth aplication?
what I'm trying to acomplish is read a sensor(ADC, I2C) and/or to modify the duty cycle of the PWM through an app but I can't find the information to create characteristics and how to modify it remotly or local
And since It's not recomended to modify the main loop how can I setup a periodical reading? using a timer?, I know the bluetooth works with events but I can't find a way to make it works
Hi Dialog,
I'm using DA1431 Basic Dev kit. I made two custom boards with DA14531 module. I debug and did SPI flash for both modules with Smart Snippet Toolbox using JTAG interface.
pin configurations
P0_2 - SWCLK
P0_10 - SWDIO
VBAT - 3.3 V
GND - GND
For past two days both modules working fine. Now I'm have a issue with one of the custom board module. which shows following error.
[ERROR General @20-09-29 10:15:46]
Hi
I want to know is there any source except timer to wake up the DA14531 from sleep mode? I should mention that I don't access my board, so I would like to wake up it remotely or by a trigger, for example, by sensing the environment.
Thanks.
We are able to use the P0_7/P0_6 defaults with the the UART sample program. But upon swithcing RX or TX to P0_2, we get nothing. Can P0_2 be used for RX or TX? Am I missing a non-obvious configuration? Thank you.
