DA14583 not found in Smartsnippets

2 posts / 0 new
Last post
Inok
Offline
Last seen:4 years 10 months ago
加入:2015-11-12 07:40
DA14583 not found in Smartsnippets

Hello,

I use the DA14583 in my own design.
For developing I use Keil ULINK Pro on the Pins SW_CLK (26) and SWDIO (25).
I can download the software from uVision and start it properly and now I want to write the code into the flash
As far I have seen this is not possible from Keil uVision 5.15 directly, it seems I need Smartsnippets.
I installed Smartsnippets V3.9, 64Bit and expect using Keil ULINK Pro as well, but when I start Smartsnippets, the project and virtual com port / JTAG selection opens but I can not see my board.

Can anybody can help me how to flash the code?
VCC_FLASH (Pin 5) is on VCC

Thanks

Keywords:
Device:
MT_dialog
Offline
Last seen:1 week 3 days ago
工作人员
加入:2015 - 06-08 11:34
Hi Inok,

Hi Inok,

The JLink debugger is the one that we are working with and all of our tools are based around this. Smart snippets isn't tested with this kind JTAG therefore is not supported.

Thanks MT_dialog