4 posts / 0 new
Last post
Tue, 2015-09-15 01:03
#1
Jonathan Forrest
Offline
Last seen:4 years 11 months ago
加入:2014-12-18 04:29
Bluetooth Qualification

Hi,

I have a product that is essentially finished. It has a matching network and a small SMD antenna.
I am aware that I can use your host sub-system and profile and pre-qualified components, however can I use the entire controller sub-system or just the LL and HCI sections?
In other words, will I have to redo the RF PHY testing as per RF-PHY.TS.4.2.1 for my Bluetooth Qualification?

Device:
DA14580
Mon, 2015-09-21 15:33
MT_dialog
Offline
Last seen:2months 2 weeks ago
工作人员
加入:2015-06-08 11:34
Hi Jonathan,

Hi Jonathan,

The RF_PHY testing always needs to be re-done, the rest of the controller can be re-used.

Thanks MT_dialog

Wed, 2015-10-28 23:32
Jonathan Forrest
Offline
Last seen:4 years 11 months ago
加入:2014-12-18 04:29
Hi,

Hi,

I assume that for the controller qualification with my RF_PHY testing I will need a copy of your LL and HCI test reports. Are these available anywhere? If not, can these be sent to me?

Thanks,
Jonathan

星期二,2015-11-03 17:01
MT_dialog
Offline
Last seen:2months 2 weeks ago
工作人员
加入:2015-06-08 11:34
Hi Jonathan,

Hi Jonathan,

Its not necessary to get the test reports. For qualification it is sufficient to use the Dialog QDID's that can be found on the Bluetooth - SIG websites.

Thanks MT_dialog