Hi,
The dev.kit.basic's datasheet page 20 shows the there is an T_RTS, T_CTS for UART Hardware flow control.
datasheet link ->http://support.dialog-semiconductor.com/download/file/fid/940
I set the basic boad's jump to use uart hardware flow control, these jump setting is the same as my previous post in the case of dev.kit.-PRO. link ->http://support.dialog-semiconductor.com/dsps-boot-flash-developent-kit-pro
and you can see the detail image from this link ->http://cfile8.uf.tistory.com/original/273F063B55C35E411BB887
However, my DSPS test using PC's hyper-terminal(set as H/W flow control) shows the something malfunctionng.
At now, I found the different info about Basic KIT can not support the H/W flow control from DSPS manual page 30. link ->http://support.dialog-semiconductor.com/download/file/fid/895
Questions.
1.BASIC kit Datasheet and DSPS manual is different. What is the exact info about BASIC KIT's UART T_CTS, T_RTS and H/W flow control ?
Hi igotit,
The Basic kit has flow control but is using the Segger J-LInk driver, the flow control on the J-Link has to be enabled in order to be used. So in order not to enable the Jink flow control an extrernal FTDI is used in the DSPS manual and plugged directly on Rx, Tx, CTS, RTS pins of the basic kit.
Thanks MT_dialog
Hi, MT_Dialog,
thank you for reply.
You mean there is a way to enable the flow control on J-Link driver ?
I really need a H/W flow control on J-Link driver.
I didn't see that info from Dialog's documentations.
Please guide what shoud I read in order to enable the flow control on the J-link driver.
Hi igotit,
A mail in the registered address has been sent.
Thanks MT_dialog