⚠️
Hi there.. thanks for coming to the forums. Exciting news! we’re now in the process of moving to our new forum platform that will offer better functionality and is contained within the main Dialog website. All posts and accounts have been migrated. We’re now accepting traffic on the new forum only - please POST any new threads at//www.xmece.com/support. We’ll be fixing bugs / optimising the searching and tagging over the coming days.
4 posts / 0 new
Last post
ZephraimMcKladden
Offline
Last seen:5 months 2 days ago
加入:2020-08-18 21:31
Segger JLink Firmware Update fails

当试图使用耐火JLinkExeit says, that there is a new firmware for the onboard J-Link OB-SAM3U128. When I do the update, it always fails at 98% with the message:

ERROR: Communication timeout. Emulator did not re-enumerate.
ERROR: Firmware update failed.

Flashing binaries with the dialog SDK (which uses JLink with JTAG itself) works.

What could be wrong here? Were can I investigate?

Device:
PM_Dialog
Offline
Last seen:31 min 18 sec ago
工作人员
加入:2018-02-08 11:03
Hi ZephraimMcKladden,

Hi ZephraimMcKladden,

Thanks for your question online. Could you please indicate if you are using any of our Development Boards?

Are you able to program the DA1469x after the update fails?

Thanks, PM_Dialog

ZephraimMcKladden
Offline
Last seen:5 months 2 days ago
加入:2020-08-18 21:31
Well, because I select all

Well, because I select all the relevant values in the comboboxes, when creating an issue, I thought my selection would be visible.
I'm using the da14695 DevKit and as I wrote, programming/flashing is not an issue, it works, also after the failed update try.

Only the update of the JLink-OB Firmware failed.

BUT: Meanwhile I tried the same DevKit with JLink.exe on a Windows PC, and the update worked without any complaints. I don't know the original reason for the failure though, as this doesn't seem to be deterministic behavior :-(

Is it possible that USB-hub effects may be a reason here?

PM_Dialog
Offline
Last seen:31 min 18 sec ago
工作人员
加入:2018-02-08 11:03
Hi ZephraimMcKladden,

Hi ZephraimMcKladden,

Glad that you got it working. Yes, probably the USB-hug might be the root cause. I’d suggest you connect it directly to you PC rather than using a USB-hub.

Thanks, PM_Dialog