DA14585: program flashed into flash, but not working. | Dialog Semiconductor customer support - 亚博全网,亚博电竞菠菜,亚博国际官网平台网址

4 posts / 0 new

Last post

Sat, 2020-08-22 07:16

Tamilarasan C

Offline

Last seen:2 weeks 2 days ago

加入:2020-08-20 07:17

DA14585: program flashed into flash, but not working.

Hi,

I have a DA14585 IoT Multi-Sensor Development Kit, I am able to run example code using Booter of smartsnippets tool and also in debug mode, but when i flash the code (ex: multi_smart_tag_585.bin) in flash memory, it is not working, but the code is flashed successfully. I didn't give any offset.

Regards,

Tamilarasan C.

Device:

DA14585

Mon, 2020-08-24 12:52

PM_Dialog

Offline

Last seen:16 hours 32 min ago

加入:2018-02-08 11:03

Hi Tamilarasan C.,

Can you please check if you make the device bootable? Before burning the SPI flash with the firmware, you should make the device bootable?

Thanks, PM_Dialog

Mon, 2020-08-24 13:02

(Reply to #2) #3

Tamilarasan C

Offline

Last seen:2 weeks 2 days ago

加入:2020-08-20 07:17

Hi,

如何检查一个d make the device bootable ?

Regards,

Tamilarasan C.

Mon, 2020-08-24 15:27

PM_Dialog

Offline

Last seen:16 hours 32 min ago

加入:2018-02-08 11:03

Hi Tamilarasan C.,

Apologies for the confusion – you should note make it bootable explicitly from the Toolbox. The specific binary is already bootable. I took a look at the DA14585_IOTP\v6.160.4\bin_v6.160.4\multi_smart_tag_585.bin and I replicated this.

Can you boot from FLASH using any other project, or this issue exists only with the multi_smart_tag_585.bin? The multi_smart_tag_585.bin is for the SUOTA feature.

Thanks, PM_Dialog