⚠️
Hi there.. thanks for coming to the forums. Exciting news! we’re now in the process of moving to our new forum platform that will offer better functionality and is contained within the main Dialog website. All posts and accounts have been migrated. We’re now accepting traffic on the new forum only - please POST any new threads at//www.xmece.com/support. We’ll be fixing bugs / optimising the searching and tagging over the coming days.
4 posts / 0 new
Last post
Tue, 2020-07-21 18:23
#1
dbonelli
Offline
Last seen:7 months 3 weeks ago
加入:2020-02-04 18:42
Recommended method for OTP

Hello,

What is the best method for OTP burning a DA14585 on a custom PCB? It is my understanding that a custom PCB can be programmed via jumper cables from a development kit, but I would like to know how Dialog Semiconductor recommends OTP burning a DA14585. For instance, should a manufacturer strictly handle OTP, should the microcontroller be OTP by a separate device and then soldered to a custom PCB, etc.?

Thanks,

Dominic

Device:
DA14585
结婚,2020-07-22 33
PM_Dialog
Offline
Last seen:9 hours 58 min ago
工作人员
加入:2018-02-08 11:03
Hi Dominic,

Hi Dominic,

I found a previous forum post that you had raised before couple of months – please check this out:

https://support.dialog-semiconductor.com/forums/post/dialog-smartbond-bluetooth-low-energy-%E2%80%93-hardware-device-reference-designs/using-jtag

Thanks, PM_Dialog

Wed, 2020-07-22 16:55
dbonelli
Offline
Last seen:7 months 3 weeks ago
加入:2020-02-04 18:42
Yes, I do recall. My question

Yes, I do recall. My question is how does Dialog Semiconductor recommend one-time programming the DA14585? Do you recommend having a manufacturer program the microcontroller before installing it onto a custom PCB? Do you recommend having some piece of equipment that handles programming the microcontroller? Do you recommend using the development kit to program a microcontroller that has already been installed to a custom PCB?

Thanks,

Dominic

Thu, 2020-07-23 14:53
PM_Dialog
Offline
Last seen:9 hours 58 min ago
工作人员
加入:2018-02-08 11:03
Hi dbonelli,

Hi dbonelli,

You should just use the OTP programmer form the SmartSnippets toolbox. Are you able to connect? I’ve also replied you in his forum thread :

https://support.dialog-semiconductor.com/forums/post/dialog-smartbond-bluetooth-low-energy-%E2%80%93-software/otp-failed-clearing-memory-address

Thanks, PM_Dialog

Accepted answer