Failure to Burn and load from SPI Flash

Dear Dialog Support Team,

I would like to get your advise about how to burn the SPI flash on Pro developement Kit (DA14585)

Since somehow the SPI is not burned and obviosly software can run from it after RESET

I Followed these steps:

• Complie using Keil peripheral_examples\blinky
• open SmartSnippets Toolbox v5.0.12.2786
• Open Board Setup tab and set:
  - SPI_CLK: P0_0
  - SPI_EN: P0_3
  - SPI_DI: P0_5
  - SPI_DO: P0_6
• Open SPI Flash/EEPROM tab
• Press on Load hex/bin file and selected peripheral_examples\blinky\Keil_5\out_DA14585\Objects\blinky_585.hex
• Press on Connect button
• Press on Read 32KB
• Read Result All 0xFF (as it should be clean Flash)
• Press on Burn & Verify button --> all pass okay (attached print screen and log file)
• Press on Read 32KB All 0xFF still having a clear Flash

Please advise what step(s) i'm missing?

*Note:

1). Attached Board picture with Jummper settings

2). Print Screen of SmartSnippets Toolbox v5.0.12.2786 after these steps

3). log file

Thanks,

Roie