Dear
I would like to know if it is possible configurate a switch in the device SLG46620. I mean, keep a signal hight or down when a clk signal rising or falling and keep the signal hight until the clk rising or falling again.
Thanks
问候
Daniel
Device:
Device Number:
SLG46620
嗨,丹尼尔,
I believe it's possible, but could you please provide an input vs output timing diagram to be sure I understood correctly.
Thanks and regards,
Pavlo
Hello
Really I want to separate a obtain signal inside greenpack into another two signal, something like te image attached. (continuous pulses separates)
Thanks
regards
Daniel
嗨,丹尼尔,
please see attached. You can run the simulation and check if it's what you need.
Hope it helps you start.
问候,
Pavlo
Hi Pavlo
Thank you very much, the solution seem perfect.
Another last question about that. Is it possible to obtain a negative voltge in a greenpack output, I mean, one of the output in the model that you sent me could be negative?
I think it is not possible inside greenpack, but in case.
Thank you very much,
Kind regards
Daniel
嗨,丹尼尔,
It's easy to do make any output inverted just changing the LUT settings but there in no option to get output voltage lower than VDD.
问候,
Pavlo
Hi Pavlo
Thank you very much.
问候
Daniel