HJ-580 DSPS service Download from arduino uart bridge (RX/ TX only)

Hello Support Team,

我之前会尝试115kbauds，以前只使用57kbauds。

I just want to bring precisions for the previous situation.

The HJ-580xp module is detected with my phone BLE scanner, his name is HJ-580XP_EE.

There is no problem to connect the phone to this BLE name, the status change to connected.

安装了一个自定义服务。

I don't know if these precisions give information on an already programmed OTP.

我试图使用Arduino串行控制台发送“AT”命令，HJ-580模块永远不会响应“确定”。我已经用RX使能引脚连接到地面而没有成功。

How to know if my HJ-580xp module has been already programmed without DSPS service?

谢谢你的帮助

JF.

Thanks

Hi Support Team,

我为您提供了关于我的配置的更多信息。我的最终目标只是通过UART的命令使用。

I use an arduino compatible board as usb/uart adaptator and I want to use it with a HJ-580 xp module.

我想使用UART唯一的模式。

When I've received this DA14580 module I don't know if it is already programmed with service like DSPS or Cordless .

我的电路板和HJ-580模块连接非常类似于对话框应用笔记中描述的例子，用于编程无线电或DSPS服务，带有基本套件，expept arduino完成的USB /序列，我只能在P0_4和TXD之间连接跳线和P0_5和RXD之间的跳线。

Is this minimal configuration correct for downloading with snippet booter?

BOOTER LOG response when I try to download the file :

[info booter @ 20-01-22 19:14:38]从文件c：\ users \ jj104874 \ downloads \ da1458x_dsps_v_5.150.2 \ da1458x_dsps \ v_5.150.2 \ projects \ target_apps \ dsps \ sps_device \ keil_5 \ out_580\ sps_device_580.hex。
[INFO Booter @20-01-22 19:14:38] Connection to COM10 port has successfully opened.
[info booter @ 20-01-22 19:14:38]开始下载程序...
[动作Booter @ 20-01-22 19:14:39]请按电路板上的硬件重置按钮开始下载过程。
[ERROR Booter @20-01-22 19:14:54] Timeout: Reset signal not detected for more than 16000 msecs.
[info booter @ 20-01-22 19:14:54]成功与COM10端口断开连接。
[info booter @ 20-01-22 19:14:54]成功与COM10端口断开连接。
[ERROR Booter @20-01-22 19:14:54] Failed downloading firmware file to the board.

当我按下模块的“重置按钮”时无检测。

当我用手机使用“BLE扫描仪应用”时，我总是检测到HJ-580xp_ee，我可以连接到它并在自定义服务下，有3个自定义特征。这是否意味着HJ-580xp的OTP已经编程了？

如果是真的，它是否会阻止片段下载，因为DA114580不是开发模式？

谢谢你的帮助(the module seller doesn't answer to my request)