Hello,
during works with DA1469X development board pro something happened and motherboard is no longer detectable as J-Link probe.
In the system (Win10) I can see Bossa Program Port under COM ports (+ 2 additional COM ports).
Also green LED near SAM chip does not lit or blink.
On the second board (attached to the same USB port) everything works as expected and J-Link is enumerating on USB and it is possible to proogram/debug DA14699 daughter board.
Is there an J-Link image available that can be written to SAM chip using BOSSA programmer?
Or maybe SAM switched somehow to bootloader mode and can return to operation as J-Link probe?
谢谢你的增刊ort.
Grzegorz
Device:
Hi ky3orr,
No, there isn’t anything shareable regarding the SAM chip. Can you please connect both pins of J6 and check if anything changed? From my understanding, the Pro-DK was fully functional, but somehow you are not able to detect it? Did I understand correctly? Did you do any modifications in the firmware? Or di you change the jumper configurations?
Thanks, PM_Dialog
Hello again,
To be speciffic I use DA14695 PRO development board with attached DA14699 daughter board.
I have not done any thanges to SAM micro firmware.
Shortening J6 does completely nothing - what is it used for?
As previously mentioned board enumerates itself on USB as BOSSA Program Port + 2 additional COM ports.
Look like SAM is running a kind of Mirochip bootloader. Maybe J-Link firmware was corrupted on one of power cycle and now bootloader executes?
Or maybe I should clone Jlink OB binary from other DA14695 PRO board and flash using BOSSA Flash Programmer from SAM devices?
谢谢你的增刊ort - currently the board is not usable.
Grzegorz
Dear support,
do you have any comments on above?
Hi Grzegorz,
I’ll reach out you in your registered email address shortly.
Thanks, PM_Dialog