SDK configuration xml file coulb not be found

⚠️
Hi there.. thanks for coming to the forums. Exciting news! we’re now in the process of moving to our new forum platform that will offer better functionality and is contained within the main Dialog website. All posts and accounts have been migrated. We’re now accepting traffic on the new forum only - please POST any new threads at//www.xmece.com/support. We’ll be fixing bugs / optimising the searching and tagging over the coming days.
2 posts / 0 new
Last post
Mon, 2019-05-20 07:47
#1
hasiky
Offline
Last seen:1 year 5 months ago
加入:2019-05-03 08:21
SDK configuration xml file coulb not be found

Hi,

When I open the SmartSnippets Toolbox, there is a warning that "SDK configuration xml file coulb not be found".

I just neglect it and try to download the hex file, and then it failed. The log is shown below.

And...I just use the simple example in SDK such as blinky.

Why didn't it work? Is it something wrong with the xml file or just another problem?

The log said,

"Connection to COM3 port has successfully opened.

Started download procedure.

Timeout: Reset signal not detected for more than 16000 msecs.

Successfully disconnected from COM3

Failed downloading firmware file to the board. "

Attachment:
PDF icon屏幕拍摄
Device:
DA14580
Mon, 2019-05-20 16:46
PM_Dialog
Offline
Last seen:8 hours 20 min ago
Staff
加入:2018-02-08 11:03
Hi hasiky,

Hi hasiky,

这个弹出窗口no effect when using the SmartSnippet studio, just press OK. Which version of the tool are you working on? Also, do you have a custom board, or you are using any of our development boards? As I can see from your attachments, you are trying to burn the SPI Flash thought UART, so a hardware reset is needed. If you didn’t reset your board, a timeout will be occurred. If you connect through JTAG, a hardware reset is NOT needed. You could find attached he steps I followed in order to connect to the SPI flash. I used the DA14580 Pro-DK and the SmartSnippets studio version 2.0.8. The jumpers should be pace in both “UART” and “SPI ” position. If you pressed the hardware reset button and the time-out was occurred, this means that you didn’t connect the UART in you board.

Thanks, PM_Dialog

Attachment:
Package iconxml_not_found.zip