How to use Smartsnippets to burn flash of EVKT-B? | Dialog Semiconductor customer support - 亚博全网,亚博电竞菠菜,亚博国际官网平台网址

3 posts / 0 new

Last post

Wed, 2014-10-29 22:23

Alex Luo

Offline

Last seen:1 year 3 months ago

加入:2014-02-28 19:16

How to use Smartsnippets to burn flash of EVKT-B?

Hello Dialog,

I tried to use Smartsnippets to burn the hex file (compiled by Keil), but it can't...
After checking the schematics of DA14580EVKT-B, it seems that its flash can be burnt by Smartsnippets. If it's not right, please let me know how to do it.

I can download the hex file into DA14580, and works well. But can't burn the flash. I tried all modes, only UART mode works and the code can be downloaded into the cheap. If using UART/SPI, and select Flish, all of the buttons inactive. For J4, I tried both UART and SPI, doesn't work either (since the chip should connect to SPI, but for connecting UART, SPI can't be used.).

please advise the setup.

Thanks,
Alex

Thu, 2014-10-30 07:52

JE_Dialog

Offline

Last seen:2 weeks 4 days ago

加入:2013-12-05 14:02

**** Alex, Smart Snippets 3.5

Hell Alex, Smart Snippets 3.5 supports writing to flash with BASIC development kit. Can you check which version of Smart Snippets you are using ? You should also be on SDK 3.0.4 or later.

Thanks & BR

JE_Dialog.

Thu, 2014-10-30 16:24

(Reply to #2) #3

Alex Luo

Offline

Last seen:1 year 3 months ago

加入:2014-02-28 19:16

嗨我,

I will update smartsnippet 3.5, and I used is the version 3.4 win32. The SDK I used is 3.0.4.
The EVK Basic version is 078_30_B, on the back witg QR code:2214_00098 480054415.
Also please let me know the process of burnning flash on this board and jumper setup on the board.

Thanks,
Alex